Micro-Blaze Out FAQ

• What is the makeup of Micro-Blaze Out?
• Is Micro-Blaze Out U/L listed?
• Are there any fluorosurfactants in Micro-Blaze Out?
• Is there butyl carbitol in Micro-Blaze Out?
• Do the microbes put out the fire?
• On what type of fires does Micro-Blaze Out work?
• Will Micro-Blaze Out work on polar solvents and alcohol fires?
• Is Micro-Blaze Out corrosive?
• Does the application require any special equipment?
• Are there any particular foam nozzles required?
• What is required to clean equipment?
• Does Micro-Blaze Out help to reduce the vapors / LELs upon application?
• How long does the Micro-Blaze Out foam blanket last?
• Is Micro-Blaze Out sold in different concentrations?
• Will Micro-Blaze Out work on MTBE?

What is the makeup of Micro-Blaze Out?

Micro-Blaze Out is a combination of surfactants, microbes and foaming agents (polymers).

Is Micro-Blaze Out U/L listed?

Yes, it is listed as a Class A and Class B agent at 2% and 3%.

Are there any fluorosurfactants in Micro-Blaze Out?

No.

Is there butyl carbitol in Micro-Blaze Out?

No. It is a non-toxic fire agent.

Do the microbes put out the fire?

No. After the fire is extinguished, there usually remain enough microbes from the overspray to begin degradation of the hydrocarbons.

On what type of fires does Micro-Blaze Out work?

On Class A fires, an application rate of ½% to 1% is recommended.

On Class B fires, the suggested application of Micro-Blaze Out is at 2%.

Will Micro-Blaze Out work on polar solvents and alcohol fires?

Yes, the suggested application rate is 3%.

Is Micro-Blaze Out corrosive?

No. It will not affect rubber, brass or metal valves. Micro-Blaze Out can be pre-mixed in booster tanks, ready to use and can remain ready indefinitely. The mixture will not turn black or septic.

Does the application require any special equipment?

No. Any type of eductor or truck mounted proportioner for foams is fine. It also reduces wear on eductors by eliminating pitting and corrosion caused by other foams.

Are there any particular foam nozzles required?

No. Any attack nozzles will work. An air aspirating nozzle is recommended.

What is required to clean equipment?

Just run water through the system and hoses for approximately two minutes.

Does Micro-Blaze Out help to reduce the vapors / LELs upon application?

Yes.

How long does the Micro-Blaze Out foam blanket last?

As a rule, depending on the application, it usually holds for approximately nine minutes. AFFF foam blankets will usually hold for around 15 minutes. The big difference is that Micro-Blaze Out will also penetrate the fire as well as eliminate flashback. If an AFFF foam blanket is disturbed, the vapors can re-ignite.

Is Micro-Blaze Out sold in different concentrations?

No — it is sold in a highly concentrated formulation to be used at different ratios.

Will Micro-Blaze Out work on MTBE?

Yes. The recommended application rate is 3%.